LIFT-MTB V4 internal DIY motor kit

LIFT MTB v4 internal crankset motor kit

A torquey motor, easily and quickly adaptable to different bikes, these are the key points that make the success of the Lift-Mtb crank motor kit.

This powerful and compact motor will allow to transform any classic bike into an electric bike with an internal motor.

First of all, the complete internal mid drive motor kit includes:

– Motor : 36 Volts / integrated controller

– Support: 7075 T6 CNC (internal mounting) upper cable clamp.

– Freewheel motor : made in France without pedaling resistance.

– The secondary plate: Type race face narrow wide ®, aluminium 7075 (30 teeth or 32 teeth)

– The primary chainring: 1/2 by 3/32 aluminum 7000 series 38 teeth.

– Primary chain: shimano® type

– The chain tensioner: with sealed ring bearing roller.

– Throttle trigger with charge indicator, on/off switch, thumb or index finger mountable.

– Screw kit: ISO 10.9 steel and complete aluminum spacer kit.

– Mounting kit: Set of Serflex steel and plastic, foam frame protection, x1 set of spare Anderson connector.

– Torque developed at the rear wheel: from 80 N.m to 110 N.m (depending on gearing)

– Maximum assistance speed: around 35Km/h to 40km/h (depending on conditions and gearing).

– Maximum speed on the flat without pedaling: from 35Km/h to 40km/h (depending on conditions and gearing).

– PIC consumption: 30 amps

– Average continuous consumption: 12 amps

– Sound volume at 150cm: “super-silent internal gears” (about 60 decibels.)

– Deco kit: Thick motocross type.

Comparison between the classic version and the pro version

First the Specifications of the pedal board if you choose the “V4 classic” version:

– Cranks: 170 mm aluminum arms specific laser engraving, chainring mounted on a Dicta® freewheel 20 points of engagement (no resistance to pedaling).

– Bottom bracket axle: chromoly 4130 heat treated, also delivered with a set of adapters of diameter 22/24 , 24 , 29 and 30mm.

-Weight: about 400 grams heavier than the “Pro” model

 

Secondly, the Specifications of the pedal board if you choose the “V4-PRO” version:

– Cranks: Aluminum 7075T6 CNC machined in France, with plate mounted on freewheel Pro 72 points of engagement (no resistance to pedaling).

– Bottom bracket axle: .chromoly 4130 hollow heat treated, also delivered with a set of adapters of diameter 22/24 , 24 , 29 and 30mm.

-Weight: about 400 grams lighter than the “CLASSIC” model

 

 

 

 

 

 

Also find articles and video of the LIFT-MTB internal mid drive motor kit below:

• Video of the mid drive motor kit
• FAQ section about the motor kit for bike

Finally, if you have any doubts, contact us.

CAUTION: KIT NOT APPROVED FOR OPEN ROAD USE.